"My Tuning" CAN-BUS Auto Tuning Module by Rapid Bike

The Rapid Bike "My Tuning" Bike kit greatly improves speed and accuracy of the Rapid Bike EVO or Rapid Bike Racing unit, but it is not necessary for EVO or RACE systems Auto adaptive tuning feature. However this kit is necessary for motorcycles that did not come with O2 sensors as an OEM equipment. If you are not sure about what to order along with your system please e-mail us for more information about your specific application, which also is necessary for any motorcycle with an ECU that has already been flashed / altered from stock.

The Rapid Bike "My Tuning" Bike kit improves the Rapid Bike module’s auto-adaptive feature to achieve a real time auto-tuning system. Using a Bosch LS 4.9 wideband O2 sensor (lambda) the Rapid Bike Evo and Rapid Bike Racing modules can perform real-time correction of the injection map with an unmatchable speed and accuracy. Up to four "My Tuning" Bike modules can be installed on the same bike (one for each cylinder, as long as the injection map is set properly).

Rapid Bike "My Tune" module kit includes a Bosch wide band sensor.

With the addition of My Tuning Bike, the function of "Map per gear" can be activated ( in most models but NOT ALL ) this feature allows 1 base map for each gear and 1 trim map for each gear allowing dedicated maps for each gear to be created and trimmed at all times.

Note: After the first engine start, the "My Tuning" Bike device registers the serial number of the Rapid Bike module to which is connected, at this point it will no longer work with any other Rapid Bike module having a different serial number. My Tuning Bike allows to set an Air/Fuel target for each cell of the map or only one target value for the entire map.

Note: A steel bung is included for the installation of the additional O2 sensor (lambda) on the exhaust pipe. The O2 sensor (lambda) for the My Tuning Bike device DOES NOT REPLACE the stock O2 sensor (lambda). It must be installed IN ADDITION to the stock equipment. However, if the stock O2 (Lambda) sensor/s have been disabled by an ECU flash or with installation of a factory option race ecu or an aftermarket ecu then My Tuning Bike Module/s can be used by itself (without the stock O2 sensor).

Note: Contact us directly to purchase multiple "My Tuning" modules if you intended to install them on multiple cylinders. It is necessary that multiple cylinder kits be special part numbers and not be the same exact kit on each cylinder.